586,354 active members*
3,305 visitors online*
Register for free
Login
IndustryArena Forum > CAM Software > GibbsCAM > GibbsCam Post for 2 axis with fanuc OT

Thread: GibbsCam Post for 2 axis with fanuc OT

Results 1 to 2 of 2
  1. 11-05-2014, 06:54 PM #1
    Adhawk
    Adhawk is offline Registered
    Join Date
    Sep 2014
    Posts
    6

    GibbsCam Post for 2 axis with fanuc OT

    Hi,

    Does anyone have a post for a Fanuc OT Control - preferably setup for a 2 axis lathe. We have no bells or whistles so if it was close it would work.

    Thanks!
    Reply With Quote Reply With Quote
  2. 11-06-2014, 03:19 AM #2
    lenny09
    lenny09 is offline Junior Member
    Join Date
    Jan 2014
    Posts
    100
    Whats your email?
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. GibbsCam post for Fanuc
    By Dr Gonzo in forum GibbsCAM
    Replies: 3
    Last Post: 03-27-2014, 04:35 AM
  2. post processor gibbscam for fanuc
    By igig2004 in forum GibbsCAM
    Replies: 4
    Last Post: 11-03-2010, 12:22 PM
  3. Centroid / Gibbscam 4th Axis POST
    By JimPAC in forum Uncategorised MetalWorking Machines
    Replies: 0
    Last Post: 09-08-2010, 03:04 AM
  4. Fanuc Oitb GibbsCAm post
    By travlinman5 in forum GibbsCAM
    Replies: 2
    Last Post: 07-10-2008, 03:15 AM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules