Useing canned cycles for inside circles & circle pockets no problem,when I program by hand useing I & J as read from G code programming articles, tool paths arent even in the ballpark.What am I missing?
Useing canned cycles for inside circles & circle pockets no problem,when I program by hand useing I & J as read from G code programming articles, tool paths arent even in the ballpark.What am I missing?
I posted this a while back which has an example:
http://www.cnczone.com/forums/bridge...ogramming.html
Do you have the DX32 programming guide?
http://www.cnczone.com/forums/bridge...832-vmc-3.html