586,296 active members*
4,103 visitors online*
Register for free
Login

Thread: Run From Here

Results 1 to 2 of 2
  1. 10-07-2014, 01:36 PM #1
    Georgethewelder
    Georgethewelder is offline Registered
    Join Date
    Oct 2014
    Posts
    2

    Run From Here

    Newby
    I have a new CNC Plasma cutting table LDR Motion Great !!! Hypertherm 85 Mach 3 when I was cutting it stopped torch went out now it lights but does not move Im going to go check now I think it says THC one line or somthing like that I think it is a run from here problem can you guys help me ?
    Reply With Quote Reply With Quote
  2. 10-13-2014, 09:02 PM #2
    dhelfter
    dhelfter is offline Registered
    Join Date
    Dec 2004
    Posts
    48

    Re: Run From Here

    George, give me a call and I can guide you. More than likely you are not getting an arc ok signal, so the machine will not move. Give me a call.
    Thanks
    Dan
    ldr motion system
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules