is there any one out there would be able to do a team viewer session with me on apart were trying to get turned that can help use write the tool paths
thanks
Russell myers
is there any one out there would be able to do a team viewer session with me on apart were trying to get turned that can help use write the tool paths
thanks
Russell myers
Did you get this done? are you still needing help. I do go to meetings to do this but there is also a charge so you know.
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Cadcam
Software and hardware sales, contract Programming and Consultant , Cad-Cam Instructor .
Yes we still need help what would the charge be and when wou l you be available
Best way to do this is to click on my name and go to Visit homepage and there you will find contact info to take this further.
regards,
cadcam
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Cadcam
Software and hardware sales, contract Programming and Consultant , Cad-Cam Instructor .
I sent you guys an email
And I am back in the office and reply-ed back.
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Cadcam
Software and hardware sales, contract Programming and Consultant , Cad-Cam Instructor .