I am looking if anyone can help out on taper multistart thread codes for GSK928TEa control. I did the multistart thread test on GSK with G76 code but now i want the threads on taper form. Anyone with a solution will be welcome.
I am looking if anyone can help out on taper multistart thread codes for GSK928TEa control. I did the multistart thread test on GSK with G76 code but now i want the threads on taper form. Anyone with a solution will be welcome.
Hi,
You need to use G32 for tapper threads.
See the manual in the link bellow for more information.
http://www.cncmakers.com/uploads/sof...ser_Manual.rar
Regards
Thanks Lara for your reply. But G32 is used for tapping cycles. I need multistart thread in taper form. G76 commands is used for this. G76 can handle the thing that i required. For the last two weeks i am working on it. Now i am very near to my goal. I develop the code for taper multistart thread. It only need to test on machine. When i will test it on machine i will surely share the code for others to utilize this.