Hey guys,

In trying to get my machine up and going again and have installed the sangmutan 2.2kw bldc motor as my spindle motor and would like to connect it to my c11g with the forward/reverse start stop functions and am a bit confused by the instructions... Was hoping someone could help me better understand them.

I was using a treadmill motor and kbb controller before and it used 0-10v to control speed but it only had a relay power on function and was poetry straight forward... This new setup is a bit different.

Page Title

the instructions can be found in the link above to see if anyone can better make sense and help me figure out how to get it working with my c11g BOB.

Thanks!

Chris