Hi

I`m doing my control panel over with a larger power supply. I have a large control box 10 deep x 24 wide x 30 tall
I have more than enough space. I am looking for recommendations for the layout of the panel. My old panel was
so tight it was a nightmare to make modifications. This is the layout so far. Power supply and din rail terminal blocks
to act as 115 volt power distribution. Fans and one of my boards are 115 ac. The power supply is mounted near the
top because I`ll have the start and stop plus disconnect installed in the top of the enclosure.
I`m wondering if I should move the BOB and the CNC4PC C17 board even further toward the bottom of the aluminum
mounting panel. Any ideas for improvements are greatly appreciated.

Attachment 252910