That's a good point. I think from load rating the 1605 is more than enough, but I would think the 2005 would be more rigid and possibly less friction assuming it has more ball bearings.
You just got yours in? What and where did you order from? I wouldn't mind buying a double nut vs making two single nuts work.
Thread: G0704 RAPID SPEEDS
Results 1 to 19 of 19
Hybrid View
-
10-20-2014, 07:13 PM #1
Registered
- Join Date
- Dec 2013
- Posts
- 158
Re: G0704 RAPID SPEEDS
-
10-20-2014, 07:16 PM #2
Gold Member
- Join Date
- Aug 2010
- Posts
- 630
Re: G0704 RAPID SPEEDS
Got it from Chai, (I.E. Linear Motion Bearings 2008) Sent him a email and got all my screws.. all of them are double nuts. I've not installed them yet.. so.. Not sure what my Z rapids would be. I would be happy with anything over 100IPM though.
Inner Vision Development Corp. - http://www.ivdc.com
Website Design & Development. Shopping Carts, SEO and more!
Reply With QuoteSimilar Threads
-
G0704 DOC, WOC, SPEEDS.. MOTOR UPGRADE?
By rs4race in forum Benchtop MachinesReplies: 10Last Post: 10-05-2014, 04:08 AM -
Bobca rapid speeds
By vector459 in forum BobCad-CamReplies: 3Last Post: 12-27-2013, 11:58 PM -
What are your rapid speeds?
By 2_jammer in forum K2CNCReplies: 4Last Post: 10-09-2012, 01:18 PM -
feed override and rapid speeds
By rkremser in forum Mach MillReplies: 1Last Post: 02-03-2009, 03:04 PM -
How to figure rapid speeds
By Hack in forum Linear and Rotary MotionReplies: 4Last Post: 09-06-2005, 01:31 PM
Tags for this Thread
Posting Permissions
