[radosi]

Hello,

I'm from Europe and found a good offer for new milling machine and I bought it !
here it is : Milling machine VF25 | Cau Cau
VF 25 L Vario
It's look like Grizzly and PM 25 MV and european Optimum BF 25 L Vario and Bernarno BF 25 L,

So my question is :

Can I use ball screw set from G0407 from supplier :
[email protected]
1pc RM1605-787.2mm with a DOUBLE BALLNUT and end machined as the drawing(the ballnut is machined as the drawing request)
1pc RM1605-345.5mm with a DOUBLE BALLNUT and end machined as the drawing
1pc RM2005-600mm with a DOUBLE BALLNUT and end machined as the drawing

or I need to build my own with the lathe from 900 600 and 400mm ballscrew.

Thanks!!!!

[radosi]

Hey guys,

after a log delay I'm back ... but still have not time for complete the conversion.

I found a photo that can be useful for all of you.

I manage to drill the pocket of the table holder with 28mm flat milling tool rotated at angle of around 30 deg.

Attachment 331440

I ordered the shafts and etc. from the chines guy and just put some bearing and they fit perfectly with my machine. I ordered this :

Attachment 331444

I hope this can be helpful for you.
notes : I have 8mm shaft step motors and one big 14mm (that's why I ordered 8 and 14mm couplings )