Thanks in advance, can anyone tell me how to change the spindle rpm. I found out how to change feed rate I now need to know how to adjust the spindle rpm.
Thanks in advance, can anyone tell me how to change the spindle rpm. I found out how to change feed rate I now need to know how to adjust the spindle rpm.
DX-32 control? It has a spindle drive. Look for STM. Input a Speed, just press enter to skip T, and a M3. You may have to press start. You need a operating manual.
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Yes a dx-32 control. The STM will not alter or adjust the once the program is running. I'm thinking it should be like adjusting the feed rate while the program is running just for the spindle.
Thanks
It depends on the version of software. Could be arrow up/down, or +/- keys.
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)