Hi everyone

I Need an urgent help with my OM control in rigid tapping Mode (G84) .

the problem is that z axis comes down to the position (R point) and spindle orients itself but it hangs there with no alarm .

the spindle rotation cw/ccw lights on the panel sequentially turn on and off .but no rotation unless i stimulate the spindle head manually .

if i do that it starts rigid tapping according to my program .

My program is:

G90 G17 G54
S200 M3
G00 G43 X0.0 Y0.0 Z100.0 H1
M29 S500 F200
G84 Z0.0 R150.0 P300 F200
G80 P0
M30

Any help would be really appreciated

[email protected]


Regards