I'm in a bit of a quandary when it comes to the Current capability of the power supply to run my 3 steppers on my converted bench mill
X and Y axis use 1605 Ballscrews with a 2:1 pulley drive and Y axis uses a 2.4:1 pulley drive (no ballscrew)
Maybe someone can help.

I have two power packs available.

24Vdc 10Amps
48Vdc 5 Amps

Given that I'm about to run a bench mill with 3 of the steppers of the specification below. Which power supply would be better suited ?

Model Voltage(V) Current /phase(A) Holding Torque(Nm) Inductance /phase(mH)
M60STH100-4004S 2.8 4.0 4 3

Please excuse if this is posted to the wrong area or forum.

Many thanks

George