Hi,

I loaded example SimpleStepDirAxis0.mot on the Config/Flash Screen, then pushed "Move" on the Step Response Screen.
Result:
1. Both IO 8 and IO 9 output same pulse.
2. IO 8 and IO 9 never stop, they always output pulse.
I don't know that you have result which is like my result?

I want to configure step/dir generator 0 like the attached image.

IO 8 (STEP pin) outputs pulse and IO 9 (DIR pin) doesn't output pulse. IO 9 only is used to determine direction of stepper motor. IO 8 outputs the specified number of pulse. Then, it stops and a task is done. Next, it outputs the specified number of pulse again and it stops again,..v..v...
Can you help me?

Thanks,
TQH