from what i gather so far on a cnc router/mill i need a spindle motor of at least 800W and a repeat tolerance of no more than .01 Will be used for wood, plastic, aluminum, silver. What would be some other min specs to look for.
Thread: General Specs
Results 1 to 2 of 2
-
09-27-2014, 10:43 PM #1
Registered
- Join Date
- Aug 2014
- Posts
- 8
General Specs
-
09-27-2014, 11:04 PM #2
Community Moderator
- Join Date
- Mar 2003
- Posts
- 35538
Re: General Specs
Smaller spindles tend to use collets with a smaller capacity. Make sure the collets can hold the largest tools you'd want to use.
Gerry
UCCNC 2017 Screenset
http://www.thecncwoodworker.com/2017.html
Mach3 2010 Screenset
http://www.thecncwoodworker.com/2010.html
JointCAM - CNC Dovetails & Box Joints
http://www.g-forcecnc.com/jointcam.html
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Reply With QuoteSimilar Threads
-
X3 specs help
By fourxblz in forum X3/SX3/G0619/G0463Replies: 5Last Post: 03-30-2013, 02:27 AM -
VF-2ss specs?
By extanker59 in forum Haas MillsReplies: 4Last Post: 05-19-2011, 08:14 PM -
Need help with the specs
By Swathi in forum DIY CNC Router Table MachinesReplies: 0Last Post: 02-26-2011, 04:13 AM -
Stepper Specs (Was Servo Specs)
By plexer in forum Stepper Motors / DrivesReplies: 1Last Post: 09-29-2005, 03:28 PM -
Servo Specs...
By CarveJunky in forum Servo Motors / DrivesReplies: 4Last Post: 05-31-2005, 02:03 PM
Tags for this Thread
Posting Permissions
