[fanuclrnr]

HI

my fanuc 0i-mc vmc is not responding due to battery fault in mornings at the time of start but after ten minutes all alarm go away. But today same problem was there with two more alarms
1. EMG STOP OR OVER TRAVEL.
2. TOOL NOT IN POSITION.
I HAVE ORDERED BATTERY FROM FANUC BUT IT WILL TAKE 3-4 DAYS DUE TO HOLIDAYS THESE ALARM ARE NOT RESOLVING.

PLEASE HELP.

[fanuclrnr]

THE OTHER ALARMS WERE;-

X AXIS SERIAL DATA ERROR (INT)

FOR ALL AXIS BUT IT GOES AWAY AFTER TEN MINUTES OF STAYING ON AND THEN RESTART.

PLEASE HELP URGENT.......

[Superman]

Battery powers the RAM that holds machine data at time of shutdown ( ie current position, current tool, parameters etc)
- RAM cannot supply the data for morning bootup.

Battery needs to be replaced ( while powered up ) before any help can be given
- you may find that the alarms will disappear

NOTE.....dead batteries in a machine is a big NO-NO.
- some machines will be boat anchors, due to loss of parameters ( a good practice is to keep a current parameter file as backup )

[fanuclrnr]

THANKS SUPERMAN FOR YOUR REPLY

WELL BATTERIES WILL TAKE TIME TO REACH AT OUR WORKS. MEANWHILE IS THERE SOMETHING THAT CAN BE DONE TO CARRY ON THE WORK BECAUSE MACHINE IS NOT WORKING.
ALSO HOW CURRENT PARAMETERS CAN BE STORED.
IS THERE ANY PROVISION TO SAVE THOSE PARAMETERS TO MY FLASH CARD THROUGH WHICH I RUN VARIOUS PROGRAMS IN MY MACHINE.