I've tried everything I can think of to get SolidCAM to do what I want it to, and that is go right down the centerline of these letters (the font is Korataki) with a ball endmill and basically engrave that lettering at .020 deep with this (or any for that matter) font.

I've tried using a profile operation and selecting the faces; the edges; curves, etc. and either the bit goes outside the lines; randomly picks letters to engrave; only mills out half the letter, etc.

I just want to drop the bit down in the center of the fonts and make one pass and a clean balled out set of letters. Any suggestions?

PS: Yes, I've checked my Geometry a million times and I can't figure this out.

Any help would be greatly appreciated.

Attachment 251298