It was pretty snugged down. I've been doing manual machining for the past 15 years and have a pretty good habit of snugging things down. Anything else it might be?
Thread: EndMill Holder pulled out of TTS
Results 1 to 20 of 26
Hybrid View
-
09-26-2014, 10:55 PM #1
Registered
- Join Date
- Jul 2005
- Posts
- 194
Re: EndMill Holder pulled out of TTS
-
09-26-2014, 11:07 PM #2
Gold Member
- Join Date
- Feb 2006
- Posts
- 7063
Re: EndMill Holder pulled out of TTS
Not really. It is important for the collet bore and TTS shank to be clean and dry, and it helps to put a VERY thin coat of anti-sieze on the collet taper. But, at 25 ft-lbs, there is NO way a 1/4" tool will EVER pull-out, unless the collet, tool shank, spindle bore, or drawbar is significantly damaged.
Originally Posted by KSky
Regards,
Ray L.
Reply With QuoteSimilar Threads
-
New Endmill Holder
By whateg01 in forum Benchtop MachinesReplies: 5Last Post: 10-04-2013, 04:21 PM -
5/32 endmill holder
By Hack in forum Metalworking- / Woodworking Tooling / Manual MachiningReplies: 2Last Post: 06-01-2009, 12:24 PM -
1/8" shank endmill holder
By CNCMike in forum MetalWork DiscussionReplies: 7Last Post: 10-24-2008, 04:58 AM -
No Endmill Holder
By DroopyPawn in forum Uncategorised MetalWorking MachinesReplies: 1Last Post: 11-21-2007, 04:14 AM -
Endmill bit and holder.
By ihkim in forum MetalWork DiscussionReplies: 0Last Post: 07-26-2005, 07:38 PM
Tags for this Thread
Posting Permissions
