We have a Bridgeport VMC800 with heidenhain 426 control. We are using a datum cutter and then bringing
all the other cutters around and touching on the same Z zero height, then using the capture button to insert
the z offset into the tool table. But then when you are programming the machine is there a way to get the machine
to use the offsets in the background and display each cutters depth from the z datum of the job (ie, the datum cutter z zero).
This is how we work on the Hurco machines we have, so I would think it was possible with the Bridgeport, just dont know how to do it!!

Thanks

Mark Newton