I just ordered it and I'm guessing I'll get it in about two weeks.

It can tilt up to 90 degrees, controlled by a handwheel instead of just a clamp that you adjust by sliding it.

The part number is supposedly TSK160 but I've seen other TSK160's that dont have a tilt-by-turnable-handle feature.

Which makes it perfect to put a motor on!! So then two motors, one for rotation, one for tilt, and now you have a fairly legitimate 5 axis setup..although only 90 degrees instead of 180 youd get with a trunnion.

I will be sure to report all my experiences with it. It weighs something like 79 to 97 lbs (kinda not clear on the specs..big surprise)

It should fit into my mill with room enough to still be able to do work.

How can I put it through the MILL so to speak (pun intended) and analyze how bad/good it is?

Comments? Thoughts? IDEAS???

It goes for $449 + $85 shipping on ebay, but I found that ebay sellers website and ordered it there for only $425 + $70 shipping, and its in the USA!

its utoole.com Home Page

I didnt get the chuck or plate thats in the picture..

6" Prcision Tilting Rotary Table