Hello everyone, I need your help, I have a CNC3040 (chinese model to understand) connected to a desktop PC with installed mach3, until a few days ago everything worked then format pc to clean it a little the next time you reinstall it happens that during the machining feed rate low (less than 1000 mm / min approximately) the machine by making circular parts stutters as if it was programmed to work in Exact Stop mode, the problem is aggravated if I go to a lot of feedrate override and the car vibrates a lot.
All this does not happen if I set the feed from 1000mm / min up.
I do not know if the problem is the machine or is it a set of Mach 3.
Thank you very much for your cooperation.
Simone