Looking for any help on this Labor day holiday.
Long story short: I had a controller failure a month ago in which I had to restore the MachOS. This all seemed to have gone well and have been running small programs since, however it only runs in demo mode limited to 500 lines of code (I didn't know this as the programs I was running were less than 500 lines).
This is discussed in the manual and says the license needs to be loaded from the license CD. Well I don't have anything called that. I did re-install the Mach3 software from the disk that I originally received and then also the ATC version over that. This is also talked about in the various manuals. And is my understanding of the procedure.
Either I am doing something wrong or don't have the required disk. Any help or pointers would be helpful. I have sent an email to Tormach but of course I won't get anything back on that till at least Tuesday.