what happened when you did your tuning with the gd tool? did you get some motion and charts of the responce of the motor? also what are your pid values? what is your scale set to? are you running step and direction or analog?
Results 1 to 20 of 50
Threaded View
-
09-02-2014, 02:22 AM #11
Registered
- Join Date
- May 2009
- Posts
- 281
Re: No encoder pulses detected on VSD-E 160 drive. Ideas?
Reply With QuoteSimilar Threads
-
New Encoder - New Cover - Ideas ???
By Bob La Londe in forum HURCOReplies: 1Last Post: 01-15-2013, 02:01 AM -
X axis drive ideas and questions
By billwann in forum DIY CNC Router Table MachinesReplies: 7Last Post: 11-17-2011, 07:56 AM -
V2XT drive fault detected
By DF-ENTERPRISES in forum Bridgeport / Hardinge MillsReplies: 5Last Post: 03-29-2010, 02:10 AM -
Multiple pulses for spindle encoder - how to install?
By LeonM in forum Mach Software (ArtSoft software)Replies: 2Last Post: 06-22-2008, 01:28 AM -
V2XT error message "DRIVE FAULT detected (0,z,y,x) check log"
By rfdoyle in forum Bridgeport / Hardinge MillsReplies: 4Last Post: 10-08-2007, 09:35 PM
Tags for this Thread
Posting Permissions
