On x axis I have average error 0.46mm / 100 mm (0,46%). Measured backlash is 0,04 mm. Should I increase 800 steps per unit up to 803,68?
Attachment 247352
Results 1 to 1 of 1
-
08-26-2014, 09:50 PM #1
Registered
- Join Date
- Jul 2014
- Posts
- 3
Should I increase steps per unit?
Reply With QuoteSimilar Threads
-
steps per unit conversion
By frige in forum Mach Software (ArtSoft software)Replies: 0Last Post: 08-16-2011, 10:37 PM -
Configuring steps/unit.....what unit?
By HereinCS in forum Mach Software (ArtSoft software)Replies: 2Last Post: 03-08-2011, 02:57 AM -
H E L P - - - Steps Per Unit
By tjskcnc in forum Mach Software (ArtSoft software)Replies: 7Last Post: 11-26-2009, 11:32 AM -
Cant get steps per unit right no matter what
By idtkid in forum Mach Software (ArtSoft software)Replies: 26Last Post: 07-01-2009, 05:14 AM -
Does increasing/decreasing stepper steps increase torque?
By bradtal in forum DIY CNC Router Table MachinesReplies: 2Last Post: 04-27-2009, 11:18 PM
Tags for this Thread
Posting Permissions
