[gbalias]

I am looking for some extra handwheels for a newer gen RF/ZX45 machine. Maybe someone has them in a box somewhere after a CNC conversion.

Im debating making some, but they have the 3 'fingers' on them (shaft diameter is .685" or so). plus, without the handwheels for mine, its kinda hard to mill them. haha.



So if anyone has anything they think that would work id be happy to discuss!

thanks!

[arizonavideo]

I have some
Send me a PM.

[CS900]

i also have some if need be.

[Mike Hall]

I too would like to find a couple hand wheels for my Enco mill. One of the handles was broken on one wheel and the left side table wheel was missing being it had a autofeed installed. I was going to just order the parts from Grizzly but none of the parts see to be available and I would rather not wait forever on them to get them back in stock.

Thanks
Mike

[KCJ]

Mike,
I have a couple of hand wheels that are just right for your mill. I don't see them being useful for much after the CNC conversion. I might put one of them on my lathe, but that leaves two unemployed. Let me know. Also gives you an exuce to head north a bit!
Kurt

[Mike Hall]

Mike,
I have a couple of hand wheels that are just right for your mill. I don't see them being useful for much after the CNC conversion. I might put one of them on my lathe, but that leaves two unemployed. Let me know. Also gives you an exuce to head north a bit!
Kurt

Kurt, you talked me into it. haha