I have a question about what bit would be a good choice for pocketing in the V-carving routine.When you do v-carving you are given the option to use a different bit to pocket with.
Would and up-cut or down-cut be the better choice. You want to get a good flat clean bottom.Will a 0 flute 2,3 or 4 flute be the better choice. You also want good clean edges.
I will be buying some bits for just this operation and want to get the right ones. SSI don't have money to waste. LoL

2nd question about V-carving. Some of the settings are not explained to well as to what they do.Is there a good Tutorial for V-carving that goes into detail about the settings.What
effect they have on each other and the project overall.

Thank You
Don