[TrepanMan]

Can anyone explain to me how the mode regrind works on the anca's, where is the information for A indexes that it probes stored at. I have been having an issue with not only mode regrind but also even the probing in general. I have even used single block to stop the tool rotation as it triggers the probe and write all my physical axes down, which usually comes out good, however when it runs any kind of finish it creates runnout due to wrong index positions it is reading. If you hit mode regrind and look at the numbers it puts in the index block under common parameters its way off.
I have a little bit of parts program editor experience and have been running anca's for almost eight years now; this is the first time I have had to avoid dig lead helix due to this reoccurring issue.

Any help would be greatly appreciated.

[steptool]

Still curious?

Sent from my XT1080 using Tapatalk