Hello,

I have a big problem with work probe from renishaw.
I calibrate the ball at 0.001mm and then with the standard macros I tryed to calibrate electronical in a bearing.
The problem is that everytime when I get my work offset in a single point X or Y I have an offset of 0.085mm.
I veryfied on an expensive vice (that is alignet also in 0.002mm) with a bar of 4mm and always after probing with renishaw the work offset on screen indicate me -2.085mm.

Please let me know if any of you had this problem and how can it be resolved.
I am working on a Haas Vf3.
I have to do precisely parts and can not work in this way.

Wait for an answer soon as possible.

Thanks in advance!