[Akbarjam]

I just got a GibbsCAM 2010 v9.5.1 and need the post Prossesor for fanuc series i . I really appreciate if any body helps me.

[john@tlt]

Can you post or send me a list of working G and M Codes? I might have something that will work

[Akbarjam]

Thank you so much John.
I found a pst for fanuc o-t which is older than series i but apparently it is working! If you know there might be some problem in future for me please let me know .
Thnaks again ,

[jamjam]

I'm in LA and am in need of a cnc rental shop, can anyone help? I have 8 speaker boxes that will take approximately 2 sheets of 4x8 and there are not a lot of cuts... well at least I think there aren't a lot!