[Kingjamez]

Hi RAF, thanks for giving it a shot! From your screen shot, it looks great. I tried opening your .bbcd file but it crashes my copy of V26 pro every time. It says "cam tree loading failed".

Could you describe in screen shot or in words how you solved the problem?

I've been working with 3D engrave, that isn't quite getting it since I can't get it to step down the wall, but I'm likely doing it wrong. I think it's been easier going to do a 2D chamfer on circles that I derive from trigonometry. At that point though, I'm essentially doing g-code by hand.

-Jim

[RAF.]

Hi RAF, thanks for giving it a shot! From your screen shot, it looks great. I tried opening your .bbcd file but it crashes my copy of V26 pro every time. It says "cam tree loading failed".

Could you describe in screen shot or in words how you solved the problem?

I've been working with 3D engrave, that isn't quite getting it since I can't get it to step down the wall, but I'm likely doing it wrong. I think it's been easier going to do a 2D chamfer on circles that I derive from trigonometry. At that point though, I'm essentially doing g-code by hand.

-Jim

Retry of just the taper tool feature - hopefully it will load

RAF.