Hello, All been a while. We have a older copy of GibbsCAM 9.#.# I dont remember, We havent paid maintenance for about 5 years now, When I was hired this place already stopped paying maintenance and they have a POST for their Milltronics 3 axis mills, and it works fine except for 1 thing, the tap is set to G84 instead of G88, Is there a way to change this, I have been doing some research and digging around, I got a hold of Compost, and PosteHAste, I found a big sweaty handfull of hundreds of post processors with their compost text files with them, but I dont have the text file for the post they use here, and I dont want to try to learn compost programming, I did track down a pdf on programming POSTS with Compost, but at a quick glance seemed involved, I have a C++ programming background but this seemed like some knowledge was missing, but that was a quick run through, anyway, any help is appreciated.