Quote Originally Posted by Steve Seebold View Post
My machine moves 90 IPM in X Y rapid. That's not very fast, but neither is 110 IPM.

Since I bought my machine in July 2011, I have learned a lot of tricks to speed up some of the processes even on a slow machine.
Steve, that is was I always told myself but after the upgrade I think I was being cheap and in denial, tool changes with the ATC are faster now and cutting seconds off of total machine time per part adds up over the course of the year and 1000's of parts. The less time the cutter is not cutting the better. I've got a Fenner to throw on, just haven't done it yet, sooner than later. Now if I can just figure out where I packed it when I moved??????????