So I installed a touchplate which recommends using the mach blue screen.


Pretty simple inputs, touch the wire to the plate; green light on the probe setting comes on like it should. The problem is when i hit the auto-z button; the router will go down a little slowly, then just drives itself into the material very quickly. The light is on so the circuit completes, but doesnt ever stop itself.

That's problem 1. Problem 2 is running my previous G-codes, which I believe is on a tool change command wants to drive the router way out off of its limits in the x/y direction. I have the tool change location set to 10/10/3.... so i'm not sure what is causing this.

None of this happened before the mach blue install, uninstalling it doesnt help the situation.