Attachment 243552Attachment 243554Attachment 243556

Hi Guys

Here are 3 pictures of my mill. The problem I'm having is the flex in the X axis front to back is enough to move the cutting bit by 1/4" by hand. For wood or plastic
it does ok but still moves a little.

By looking at the pictures, can you see any changes that I can make to stiffen up the X axis? Are the rods too close together? The machine is all aluminum
frame and weighs several hundred pounds or more. O bought it preassembled and ready to run. A few minor things were broken in shipping that have been
fixed or replaced.

Any ideas or suggestions are welcome.

John Frankforther