oops, just looked at your post again, ( your comment about no Z on arcs )......... it doesn't post any Z outputs on an arc
Your post
Code:
pcir # Circular interpolation 2
pnmark, sgplane, sccomp, sgcode, pxy, i, j, pfr, pcan
Fanuc X5, 3 axis post
Code:
pcirout1 #Output to NC of circular interpolation
pcan1, pbld, n$, `sgfeed, sgplane, sgcode, sgabsinc, pccdia,
pxout, pyout, pzout, pcout, parc, feed, strcantext, scoolant, e$
notice the difference ie pxy is same as pxout & pyout combined, but there is no reference to a Z output in your postblock
- your post will only do planar movement on arcs
I would say linear ramp is your only option
I say that really sucks capability wise with what is considered normal practice with today's tooling
IMO, you may have to look thru your other posts that have the ramp on arc capability, & modify it to get the same code output....this will be difficult & a bit time consuming as you would have to post code & then prove it on your machine ( even if modified by someone else)