I have a VM16 with Centurion 6 control that is no longer executing tool changes, as it stands all the hardware associated with the tool changer, drawbar, lock out mechanism and its air cylinder have been verified as operational, so I am positive its a software issue.
I am hoping to compare notes with someone on the power settings to see if changes made on our end (under advice from Milltronics support) were erroneous. The changes have resulted in the mill no longer executing M19 commands and failing to home the tool drum when running an M20 (it will just continuously spin, even though the sensor will see the stop point and send a signal).
The folks at Milltronics have been great, but I am feeling really bad about bothering them anymore.
As a side note, the IT company I hired to set up the mill to our network managed to wipe the restore files off my restore floppy.
Any help greatly appreciated.