Hi all (My First Post)
really need help with this

We were using really old Hypermill software V6 SP
Bridgeport series 1 Interact 2 TNC151 & 370
The PC this was running on was 12 years old had a floppy that didn't work and no USB
the only way to get a new program on was to burn to CD from my PC
I thought it would be a good idea to update it to a slightly newer PC
between myself and IT we fumbled our way through re installing the software
transferring the licences etc but we hit a problem so tried starting the old PC up
and worst ting that could happen,,,,HD fried

Anyway that's the background info

When we run calculate we get an error message :-

Hypermill Cycleoutput
Operation 1
OPEN MIND ERROR = Cycle Cc not installed

No toolpaths show up, nothing just sits there

Any Help Appreciated

PS please do not advise to contact Openmind they didn't want to know
just wanted to sell us the latest software the and there's no way the company will pay thousands out again
for what we use it for we're a small in house mould repair shop we don't use the software that often but
when we do its worth its weight etc

Regards Eddie