My C axis is throwing alarm # 71 in the panel on the servo drive. Makino has replaced the servo and same results. My 3R indexer has been sent to Makino for testing nothing wrong.
Any ideas would be much appreciated.
Dave
Results 1 to 2 of 2
Threaded View
-
07-24-2014, 02:06 PM #1
Registered
- Join Date
- Jul 2014
- Posts
- 4
Makino SP64 Wire EDM servo C axis alarms
Reply With QuoteSimilar Threads
-
Help with alarms ("401 x axis servo vrdy signal off and 701 fan motor overheat)
By MCImes in forum FanucReplies: 4Last Post: 12-16-2011, 04:15 AM -
MAKINO WIRE EDM..EE3/EE6
By R Pikula in forum EDM Discussion General TopicsReplies: 1Last Post: 10-05-2010, 04:07 PM -
MAKINO 55e ALARMS!!!!
By Perfectune in forum DNC Problems and SolutionsReplies: 3Last Post: 03-02-2010, 03:43 PM -
Makino EC 3025 Wire EDM
By engrnrk in forum EDM Discussion General TopicsReplies: 0Last Post: 02-26-2010, 09:34 PM -
Old junk Makino Wire Cut
By Ch_Irawan in forum EDM Discussion General TopicsReplies: 3Last Post: 08-10-2008, 01:11 PM
Tags for this Thread
Posting Permissions
