Hi,
I have a Mitsubishi 90SZ that will not start after moving it to my new shop. The machine started just perfectly before moving it, now I get servo alarm 017 OR 033.
The feeling is that it has something to do with input power. Backup battery is bad so I have to reload software if it's been without power for more than 1 day or so.
I get no alarms on the servo amps while loading the software but when I power it up to load the language disk, the alarms will show.
I have 200V between the phases at the machine but 0V between phase and ground, is this really normal? Since we have 400V here in Sweden there is a transformer before the machine.
Sorry for poor english but I hope you understand!
/R