586,690 active members*
3,051 visitors online*
Register for free
Login

Thread: Geometry offset

Results 1 to 3 of 3
  1. 07-18-2014, 12:24 AM #1
    Amboy
    Amboy is offline Junior Member
    Join Date
    Jul 2014
    Posts
    20

    Geometry offset

    Is there any parameter to lock geometry offset of fanuc 18 i controller of a kitako or muratec lathe?
    Reply With Quote Reply With Quote
  2. 07-19-2014, 03:39 PM #2
    viorel26
    viorel26 is offline Registered
    Send a message via Yahoo to viorel26
    Join Date
    Jun 2007
    Posts
    119

    Re: Geometry offset

    param. 3290 #1
    Reply With Quote Reply With Quote
  3. 07-21-2014, 04:30 AM #3
    Amboy
    Amboy is offline Junior Member
    Join Date
    Jul 2014
    Posts
    20

    Re: Geometry offset

    Hi Viorel 26,

    Thank you very much. i tried already and it works with the MDI mode and PWE enable. I wonder if it can be done thu edit mode key not in PWE. Again thank you.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Weird behavior in the 2D Geometry tab: Mouse offset?
    By Wirecutter in forum SprutCAM
    Replies: 17
    Last Post: 04-07-2013, 04:34 PM
  2. Fanuc 6T-B Geometry offset
    By bogdanz in forum Uncategorised MetalWorking Machines
    Replies: 11
    Last Post: 01-30-2013, 07:20 AM
  3. Tool Geometry / Offset
    By WaterjetWillie in forum Daewoo/Doosan
    Replies: 2
    Last Post: 06-12-2010, 05:10 PM
  4. Tool geometry offset Y-axis
    By Dlo in forum Mori Seiki lathes
    Replies: 5
    Last Post: 05-13-2010, 07:26 AM
  5. Lathe geometry offset
    By cncdigger in forum CNC (Mill / Lathe) Control Software (NC)
    Replies: 2
    Last Post: 01-29-2007, 11:52 PM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules