My C# 2010 Application runs, and works with KFlop, but not independent of dev. prog?
My new CNC C# program, works as it should, as long as I am running from C# 2010 program, even without debug.
Then I publish it... and I get the error below. During and after trying to install the program. Even on the same computer, and on my laptop?
__________________________________________________ _____________________________________________
Problem signature:
Problem Event Name: CLR20r3
Problem Signature 01: truemachinecnc4.exe
Problem Signature 02: 1.0.0.0
Problem Signature 03: 53bbf267
Problem Signature 04: KMotion_dotNet
Problem Signature 05: 1.0.1.0
Problem Signature 06: 5133ac38
Problem Signature 07: 3a
Problem Signature 08: e1
Problem Signature 09: KMotion_dotNet.DMException
OS Version: 6.1.7601.2.1.0.768.3
Locale ID: 1033
Additional Information 1: 0a9e
Additional Information 2: 0a9e372d3b4ad19135b953a78882e789
Additional Information 3: 0a9e
Additional Information 4: 0a9e372d3b4ad19135b953a78882e789
__________________________________________________ ________________________
I am not sure why the program works so well in the development enviroment... and then not from the Release folder... or after install?
Any help would be much appreciated.
__________________________________________________ ________________________
I have tried to move all the .dll's over from Kmotion release to my release folder, and the two manifest files... but still the error.
Tried to run as admin.
Thanks in advance...
,
Robot & Machine Design - BLUECNC4, GreenCNC3, RedCNC2L, SilverCNC2; CNC Software!
www.truemachinedesign.com - - - - - - - - - - - - - www.truemachineautomation.com