Hi,

The tool selection displayed on the controller is not the same as the tool selected in the turret. For example, while tool 1 is currently selected in the turret, the control is displaying tool 11.

All the axes move freely and the turret indexes properly in both directions, it just isn't displaying the right tool.

The machine is a Daewoo Puma 2000SY and the controller is a Fanuc 18i-T

I recently replaced the battery on the turret servo using the steps that M-man posted in this thread: Daewoo Puma 300 lathe turret alarm - Page 2. I am unclear as to whether the fourth step is necessary, as I am able to move all the axes to their reference positions.

If anyone had any ideas, it would be greatly appreciated.