Greetings everyone,

I have a Fanuc 18i Model B LCD mounted control running a multi-axis type FSSB servo amplifier (A06B-6096-H301). Now the problem is that I'm trying to jog 1 axis at a time on a multi-axis servo amplifier. I tried disabling 2 of the axes and setup the first axis as the X axis, but the problem is every time I reset the control I get the servo alarm 401 (V ready off). I tried to set the other 2 axes as Y and Z. Then I tried to detach them from the control, but I got the servo alarm 404 (V ready on). My question is is it possible to run 1 axis at a time on a multi-axis servo ampilifier with a type FSSB interface? I know it's possible on the earlier versions on the servo amplifiers by terminating the JV*B port. And if possible what would be the required parameters to make this happen?