Im looking for a Tormach Mastercam post for X5 that supports metric and the ATC? Can anyone help?
Will
Im looking for a Tormach Mastercam post for X5 that supports metric and the ATC? Can anyone help?
Will
I don't know about the ATC, but I use the basic Fanuc (MPFAN) post for mine and it works fine.
Atc shouldn't need any special post processing
Sent from my SM-G900V using Tapatalk
The ATC doesn't need any special post from Mastercam. All that's needed is an M6 and a tool number and the control will handle the rest.
www.benchtopprecision.com
| BF20/G0704 Belt Drive Kits | X2 Mini-Mill Belt Drive Kits |
Example
M6 T10 G43 H10
It doesn't need an M998 or whatever it is
Look on the tormach yahoo group. There are mastercam posts on there.
Cheers
Thanks for the replies, I had worked it out my self, i edit the code produced by master cam as per Bamcnc's example M6 T10 G43 H10 and it works fine,( Mastercam breaks this up over a few lines) if you are only using a couple of tools and don't have the ATC setup the machine stops for a manual tool change.
Will