I bought this almost new VFD and was going to make a "ton of money" selling conversions for Monarch Lathes ... Then got sick (surgery) and it's been sitting for a year.
This unit is completely wired with a 60 amp disconnect , relays etc mounted in a NEMA enclosure ... ( It's really purty ) I will change the controls for any machine you want to install it to so all you have to do is hook up Power, motor and start-stop.
No reasonable offer refused
Results 1 to 2 of 2
-
06-11-2014, 06:07 PM #1
Registered
- Join Date
- Oct 2013
- Posts
- 57
Magnetek/Yaskawa 10 HP VFD - 230 volts Wife says "get it outa here"
-
06-11-2014, 10:15 PM #2
Registered
- Join Date
- Mar 2012
- Posts
- 378
Re: Magnetek/Yaskawa 10 HP VFD - 230 volts Wife says "get it outa here"
Sent you a PM.
Reply With QuoteSimilar Threads
-
LinuxCnc "Step Time" "Step Space" "Direction Hold" "Direction Setup" values??
By blau_schuh in forum Dmm TechnologyReplies: 5Last Post: 01-12-2014, 07:07 PM -
X Axis "Goes Off Pattern", "Awry", "Skewed", "Travels"
By DaDaDaddio in forum Laser Engraving / Cutting Machine General TopicsReplies: 1Last Post: 05-06-2013, 09:59 AM -
Low resolution curves using "Create Curve on Edges" or "silhouette boundary"
By slideleft in forum MastercamReplies: 2Last Post: 11-16-2012, 03:17 AM -
BattleAxe "aka" Ball and Chain "aka" the wife.
By ZipSnipe in forum Community Club HouseReplies: 48Last Post: 05-18-2008, 03:53 PM
Tags for this Thread
Posting Permissions
