Hi, I have a Perske that probably needs a rebuilt motor and rebuilt bearings. A vfd single phase 230 in to 3 phase 230 out is also needed.
Anyone no of a good rebuilder or a used replacement in good condition.
Thanks,
Ddog
Hi, I have a Perske that probably needs a rebuilt motor and rebuilt bearings. A vfd single phase 230 in to 3 phase 230 out is also needed.
Anyone no of a good rebuilder or a used replacement in good condition.
Thanks,
Ddog
You can pick up a water cooled chinese 3HP spindle on Ebay, with VFD, for less than you're rebuild would cost.
http://cgi.ebay.com/2-spindle-motors...3%3A1|294%3A50
Gerry
UCCNC 2017 Screenset
http://www.thecncwoodworker.com/2017.html
Mach3 2010 Screenset
http://www.thecncwoodworker.com/2010.html
JointCAM - CNC Dovetails & Box Joints
http://www.g-forcecnc.com/jointcam.html
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)