[CNCFanMx]

Please anybody help me.

My mini mill does not turn on, today in the morning was working ok, in the afternon want change the tools to do another part but when try to turn on only recived a message on the cgreen

Attachment 238010

Is any way to reset the machine..?? or something to do.

thanks in advance

[djr76]

Did you try turning it off then on again? From time to time I get a black screen on an older hl2 that I have to do this to.

[haastec]

Please anybody help me.

My mini mill does not turn on, today in the morning was working ok, in the afternon want change the tools to do another part but when try to turn on only recived a message on the cgreen

Attachment 238010

Is any way to reset the machine..?? or something to do.

thanks in advance

Looks to me like the machine lost it's memory; software/parameters everything. Time to get a tech in to reload everything. Do you have a backup of machine parameters, settings, etc?

Bigger question though is why. A bad backup battery will cause the same issue, but not until the machine is powered off.

[CNCFanMx]

Yes i did, not working...

thanks for your answer

[Precision MT]

Did you happen to get a 124 alarm before this happened?

[CNCFanMx]

no alarm happened. the machine was working ok in the morning, when i try to turn it on in the afternoon, thats what happend. only the screen lines. do not turn it on.

Thanks for your time and answer.

[Precision MT]

Check all voltages, especially the low volt power supply. It sounds like a bad processor, but it's hard to diagnose without standing in front of it. Let us know what you find.

Thanks,

Phil