Hello All
We have Haas vf9
Would like to transfer NC program from PC to Haas via RS-232 with CIMCO Editor.
I hope all my settings & Cable are okay.
I can send a program from Haas to PC (SEND RS-232).
but when I transfer NC program from PC to Haas machine(RECEIVE RS-232), at pc it says successfully transferred. but at Haas machine it says still WAITING FOR DATA......
My settings at PC:
COM 1
9600 Baud Rate
Stop Bits 1
Data Bits 7
Parity Even
Flow Control : SOftware
Tick Enable DTR
Tick Enable RTS
\17 XOn Character
\19 XOff Character
Receive Tab:
CR/LF Auto
Remove Character:Al Below ASCII 32
Transmit Tab:
CR/LF \13\10
please advise...
Regards
ravi