I put a tool in the wrong location on my carousel and bumped into an already chucked tool. Now my router says tool changer out of position. Any Ideas would be appreciated.
thanks ben
I put a tool in the wrong location on my carousel and bumped into an already chucked tool. Now my router says tool changer out of position. Any Ideas would be appreciated.
thanks ben
Did you try turning it off, then back on, and re-calibrate?
Also, check if there's a proximity sensor on the carousel that may be damaged.
Gerry
UCCNC 2017 Screenset
http://www.thecncwoodworker.com/2017.html
Mach3 2010 Screenset
http://www.thecncwoodworker.com/2010.html
JointCAM - CNC Dovetails & Box Joints
http://www.g-forcecnc.com/jointcam.html
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Thanks Gerry- I tried off/on re calibrate already... no dice. The carousel is stuck between positions and does not know where it is. I tried manual movements it does not turn. I am at a loss.
Hi did you ever get this problem solved? I have just done the same.
Managed to sort by playing around with the limit switches. Yes i work with a 220.
The reason I ask is we bought a 220 with a bum drilling unit, we fixed the drill unit now need to find the proper servo pack. Question: Do you have drilling unit? If yes, could you you peek into the cabinet and tell me what your servopack reads. Should be a Yaskawa brand if still stock. Should be the pack that sits at tor right of the four. Scm wants to sell me a brandy new one for big bucks and is being tight lipped about it.
Thanks Ben
Im not that clued up on the inner workings. We have a vertical drilling head and an aggregate drill thats never been used. I will have a look when I am back in after Easter and take some photos.