Well, we've been running the orang-ish looking colored one from the first picture for about 4 months straight now on an 80X w/ an EnduroMax pump running just under 50k pressure. One job we ran last week consisted of about 20,000 pierces. We put a new factory yellow cup on the 55100 in the shop here about a month and a half after the WJS cup was put on the 80x, and it looks like the factory cup is getting ready to fail any day now, while the one on the 80x still looks like it's got a lot of run time left in it.

Hoping to try and market these, but not really sure how to go about it or where to offer them. Shown below is our first small batch trial run to test the waters before we invest in a bigger mold to run multiple pieces at a time and start making them in volume.

Attachment 251060