Hello all,
Was renaming programs on our Crown L1060 and lost a program. The function had been working fine until this glitch. So is there another memory I can access or is this gone for good. I have all the factory manuals and they are pretty useless for troubleshooting. Any direction you could point me into would be much appreciated. Thanks.
Results 1 to 4 of 4
-
08-02-2014, 02:08 PM #1
Registered
- Join Date
- Feb 2009
- Posts
- 15
Okuma OSP - 10L lost program help needed
-
08-02-2014, 04:08 PM #2
Registered
- Join Date
- Apr 2006
- Posts
- 822
Re: Okuma OSP - 10L lost program help needed
What is the Control system for your machine?
If it one of the"P" series, where the control system is an embedded version of Windows then there MIGHT be a chance, but if not, then you are well out of luck.
-
08-02-2014, 11:24 PM #3
Registered
- Join Date
- Feb 2009
- Posts
- 15
Re: Okuma OSP - 10L lost program help needed
It's Okumas own system. OSP - 10L is what is on the control.
-
08-02-2014, 11:55 PM #4
Gold Member
- Join Date
- Feb 2009
- Posts
- 6028
Re: Okuma OSP - 10L lost program help needed
There was always a recover mode. I believe you type in the filename;R. Only works on last program edited and if you powered down its gone.
Reply With QuoteSimilar Threads
-
Okuma OSP - 10L lost program help needed
By travelingman in forum OkumaReplies: 3Last Post: 08-03-2014, 09:26 PM -
Unit has lost it's program on the C80010 Memory Module
By 1partschick in forum Cincinnati CNCReplies: 0Last Post: 09-12-2013, 02:50 AM -
lost new program
By G00 in forum OkumaReplies: 6Last Post: 06-27-2011, 06:24 AM -
lost plc program hitachi HG400II
By wilfrid in forum DNC Problems and SolutionsReplies: 0Last Post: 05-01-2011, 10:33 AM -
Johnford VMC 750 with Fanuc O-MC lost O9000 program
By zpewei in forum FanucReplies: 9Last Post: 02-28-2010, 04:02 AM
Tags for this Thread
Posting Permissions
